Blog

Repairing large holes in drywall—anything over six inches—is different from fixing a small hole in drywall. Small holes can be patched over with drywall tape or a self-adhesive drywall patch, but large holes need a more rigid material to span over the larger opening.Aug 10, 2021

You don't have time to repaint the entire wall to ensure every mark is covered and the color is the same. However, touch-ups are tricky. Most times the paint will not match unless you have the original paint. That's why Walla Painting suggests you keep the paint we use after we do your project.

Holes and cracks may let wind, construction residue, insulation, pests, and moisture into your home. Drywall damage also makes your home less energy efficient, as heat and air conditioning escape through damaged regions of drywall.

Toothpaste + Aspirin

Toothpaste works best for small holes in the wall, particularly because it tends to crack. To avoid cracking, crush up some aspirin into powder, and mix it with a bit of toothpaste to create a paste. Then, apply the toothpaste-aspirin mix to the wall and let dry.Jan 6, 2016

Use a putty knife to fill them with spackling or wall joint compound. Allow the area to dry, then sand lightly. Anything larger must be covered with a bridging material for strength before patching compound can be applied.

Use spackle to repair holes less than 4 inches (10 cm) in diameter. Spackle can be used to repair holes up to the size of your hand. You will have to use a support like mesh or wire to repair holes larger than 4 inches (10 cm) in diameter. Buy light spackle at the local hardware store.

If you attempt to install a screw or anchor in joint compound, it will pull out of the wall. Spackle is not durable enough to fill a screw hole for reuse. If you attempt to insert a screw, anchor, or bolt into spackle, the fastener will pull out of your wall.

• Fixing a Very Small Hole in a Wall Purchase spackling paste and a small putty knife if repairing a very small hole. Spread a small amount of spackling paste over the hole with your putty knife. Smooth the spackling paste out with your putty knife. Allow the spackling paste to dry and then paint the patch, if necessary.

• If you are patching a larger void, a two-coat approach is probably best. Fill the edges of the hole with plaster, covering the tape or screening. Use a small filler knife, and bring the plaster just shy of the surrounding finish plaster. Let the newly applied patch set overnight.